Digimerge DPV24D Instruction Manual download pdf (Page 10)

-6-

INSTALLATION. VANDAL DOME

1) Remove the three tamper screws using the provided

allen key. Size is standard T-15

Note: If you plan to use conduit tting, remove conduit

cap using the prodivded conduit key.

DPV24TLX ONLY

When using DC power, note the correct polarity stated on the

label attached to the power cord.

Note: If you plan on installing onto a junction

box, attach provided tting plate rst to

the junction box and then you attach the

camera base to the tting plate.

3a) Reinsert camera module into camera base

by ligning up the arrow notches, and turning

camera module clockwise to lock into place.

3b) Use the supplied three base locking screws to

secure camera base to camera module.

Go to step

on page 7 to complete installation.

Method 1 - Direct Attach Install

2a) Use included mounting template to mark and pre-

drill the required holes. Use 2pc of the 2.8” screws

to mount the camera directly to the mounting

surface.

Remove (one base locking screw, used for shipping

purposes) and install the 3rd 2.8” screw.

Go to step

on page 7 to complete installation.

Method 2 - Camera Base Install

Note: Use this method if installing onto junction box

plate.

2b) Remove the camera base by unscrewing the base

locking screw, and turn camera module approx. 5

degrees counter-clockwise to detach camera base

from the camera module. Now you install the base

to the correct holes as indicated on the mount

template using the 1.2” screws.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

No comments

Digimerge DPV24D Instruction Manual Page 10